H3C MSR810 - Map Ppp; Mtu

213
map ppp
Use map ppp to create a PPPoA mapping for a PVC or PVC-group.
Use undo map ppp to delete the PPPoA mapping.
Syntax
map ppp virtual-template vt-number
undo map ppp
Default
No PPPoA mappings for a PVC or PVC group exist.
Views
PVC view
PVC-group view
Predefined user roles
network-admin
Parameters
vt-number: Specifies the number of the VT interface corresponding to a PPPoA mapping. The VT
interface must have already been created.
Usage guidelines
aal5snap and aal5mux encapsulations support PPPoA mapping.
A PVC or PVC-group can be mapped to only one VT interface.
This command is not applicable to PVCs in a PVC-group.
Examples
The following example demonstrates a complete process of PPPoA configuration.
# Create a VT interface Virtual-Template 10, and configure an IP address for it.
<Sysname> system-view
[Sysname] interface virtual-template 10
[Sysname-Virtual-Template10] ip address 202.38.160.1 255.255.255.0
[Sysname-Virtual-Template10] quit
# Create PVC 1/101 on interface ATM 2/4/0.
[Sysname] interface atm 2/4/0
[Sysname-ATM2/4/0] pvc 1/101
# Create a PPPoA mapping using the created VT interface.
[Sysname-ATM2/4/0-pvc-1/101] map ppp virtual-template 10
Related commands
encapsulation
mtu
Use mtu to configure the MTU for an ATM interface.
Use undo mtu to restore the default.