H3C MSR810 - Timer-Hold

353
undo snmp-agent trap enable fr
Default
SNMP notifications are disabled for Frame Relay.
Views
System view
Predefined user roles
network-admin
Examples
# Disable SNMP notifications for Frame Relay.
<Sysname> system-view
[Sysname] undo snmp-agent trap enable fr
timer-hold
Use timer-hold to set the DTE-side T391 timer.
Use undo timer-hold to restore the default.
Syntax
timer-hold seconds
undo timer-hold
Default
The DTE-side T391 timer is 10 seconds.
Views
Interface view
Predefined user roles
network-admin
Parameters
seconds: Specifies the DTE-side T391 timer in the range of 0 t o 32767 s econds. The value 0
indicates that the LMI protocol is disabled.
Usage guidelines
This command is available on DTE interfaces.
The DTE-side T391 timer defines the interval at which the DTE sends status enquiry messages.
The DTE-side T391 timer must be smaller than the DCE-side T392 timer.
Examples
# Set the type of Frame Relay interface Serial 2/1/0 to DTE. Set the T391 timer to 15 seconds.
<Sysname> system-view
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] link-protocol fr
[Sysname-Serial2/1/0] fr interface-type dte
[Sysname-Serial2/1/0] timer-hold 15