139
[Sysname] interface hdlc-bundle 1
[Sysname-HDLC-bundle1] bundle load-balance per-flow
bundle max-active links
Use bundle max-active links to set the maximum number of Selected interfaces allowed in an
HDLC link bundle.
Use undo bundle max-active links to restore the default.
Syntax
bundle max-active links number
undo bundle max-active links
Default
The maximum number of Selected interfaces allowed in an H DLC link bundle is the maximum
number of Selected interfaces supported by the device.
Views
HDLC link bundle interface view
Predefined user roles
network-admin
Parameters
number: Specifies the maximum number of Selected interfaces allowed in an HDLC link bundle. The
value range for this argument is 1 to 16.
Usage guidelines
The value specified by using this command cannot be s maller than the value specified by using
the bundle min-active links command.
Use the bundle max-active links command together with the bundle member-priority command
to make sure both ends of a link always have the same Selected status. The communication fails
when one end is Selected but the other end is Unselected.
Examples
# Set the maximum number of Selected interfaces allowed in HDLC link bundle 1 to 8.
<Sysname> system-view
[Sysname] interface hdlc-bundle 1
[Sysname-HDLC-bundle1] bundle max-active links 8
Related commands
bundle member-priority
bundle min-active links
bundle member-priority
Use bundle member-priority to set the bundling priority value for an HDLC-enabled interface.
Use undo bundle member-priority to restore the default.
Syntax
bundle member-priority priority
undo bundle member-priority
To Next Page
Loading...
