H3C MSR810 - Fr Fragment Size; Fr Inarp

339
This command and t he fr traffic-shaping command are mutually exclusive on an i nterface. For
more information about Frame Relay traffic shaping, see ACL and QoS Configuration Guide.
Examples
# Enable Frame Relay FRF.12 fragmentation on Serial 2/1/0.
<Sysname> system-view
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] link-protocol fr
[Sysname-Serial2/1/0] fr fragment enable
fr fragment size
Use fr fragment size to set the fragment size allowed on a Frame Relay interface.
Use undo fr fragment size to restore the default.
Syntax
fr fragment size size
undo fr fragment size
Default
The fragment size allowed on a Frame Relay interface is 45 bytes.
Views
Interface view
Predefined user roles
network-admin
Parameters
size: Specifies the fragment size in the range of 16 to 1600 bytes.
Examples
# Set the fragment size to 300 bytes on Serial 2/1/0.
<Sysname> system-view
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] link-protocol fr
[Sysname-Serial2/1/0] fr fragment size 300
fr inarp
Use fr inarp to enable Frame Relay InARP on a Frame Relay interface.
Use undo fr inarp to disable Frame Relay InARP on a Frame Relay interface.
Syntax
fr inarp ip [ dlci-number ]
undo fr inarp ip [ dlci-number ]
Default
Frame Relay InARP is enabled on a Frame Relay interface.
Views
Interface view