240
Parameters
text: Sets an interface description, a case-sensitive string of 1 to 255 characters.
Examples
# Set the description to Cellular-intf for Cellular 2/4/0.
<Sysname> system-view
[Sysname] controller cellular 2/4/0
[Sysname-Cellular2/4/0] description Cellular-intf
display cellular
Use display cellular to display call connection information for a 3G/4G modem.
Syntax
display cellular [ interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface-number: Specifies a c ellular interface by its number. If you do not specify a c ellular
interface, call connection information for all cellular interfaces with 3G/4G modems installed is
displayed.
Usage guidelines
The command output might vary by modem manufacturers.
Examples
# Display call connection information for Cellular 2/4/0 (WCDMA network).
<Sysname> display cellular 2/4/0
Cellular2/4/0:
Hardware Information:
Model: E176G
Modem Firmware Version: 11.604.09.00.00
Hardware Version: CD25TCPU
International Mobile Subscriber Identity (IMSI): 460029010431055
International Mobile Equipment Identity (IMEI): 353871020138548
Factory Serial Number (FSN): DK9RAA1871500602
Modem Status: Online
Profile Information:
Profile 1: Active
PDP Type: IPv4, Header Compression: Off
Data Compression: Off
Access Point Name (APN): 001
Packet Session Status: Inactive
Modem Setup Information:
Diagnostics Monitor: Close
Network Information:
To Next Page
Loading...
