H3C MSR810 - Ppp Mp Mp-Group

55
Views
VT interface view
Dialer interface view
MP-group interface view
Predefined user roles
network-admin
Parameters
size: Specifies the minimum MP packet fragmentation size in the range of 128 t o 1500 b ytes.
Outgoing MP packets less than the minimum value will not be fragmented, and those greater than or
equal to the minimum value will be fragmented.
Examples
# Set the minimum MP packet fragmentation size to 500 bytes on MP-group 2/0/0.
<Sysname> system-view
[Sysname] interface mp-group 2/0/0
[Sysname-MP-group2/0/0] ppp mp min-fragment 500
ppp mp mp-group
Use ppp mp mp-group to assign an interface to an MP group, and enable MP for the interface.
Use undo ppp mp to restore the default.
Syntax
ppp mp mp-group mp-number
undo ppp mp
Default
An interface is enabled with PPP.
Views
Interface view
Predefined user roles
network-admin
Parameters
mp-number: Specifies an MP-group interface by its number.
Usage guidelines
This command should be used with the interface mp-group command. You can create an MP group
interface and then assign an interface to the MP group. You can also assign an interface to an MP
group and then create the MP group.
Examples
# Assign Serial 2/1/0 to MP-group 2/0/0.
<Sysname> system-view
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] ppp mp mp-group 2/0/0
Related commands
interface mp-group