H3C MSR810 - Service Vbr-Nrt

225
Parameters
output-pcr: Specifies the peak output rate of ATM cells in kbps. For more information about the value
range, see Table 47.
Usage guidelines
You can use this command as well as the service cbr, service vbr-nrt,
and service vbr-rt commands to set the service type and parameters of a PVC. If you execute this
command multiple times, the most recent configuration takes effect.
Examples
# Create a PVC named aa on the interface ATM 2/4/0, and set the VPI/VCI, service type,
and output-pcr to 1/101, UBR, and 100000, respectively.
<Sysname> system-view
[Sysname] interface atm 2/4/0
[Sysname-ATM2/4/0] pvc aa 1/101
[Sysname-ATM2/4/0-pvc-aa-1/101] service ubr 100000
# Create a PVC named aa in PVC-group 1, and set the VPI/VCI, service type, and output-pcr to
1/101, UBR, and 100000, respectively.
<Sysname> system-view
[Sysname] interface atm 2/4/0
[Sysname-ATM2/4/0] pvc-group 1
[Sysname-ATM2/4/0-pvc-group-1] pvc aa 1/101
[Sysname-ATM2/4/0-pvc-group-1-pvc-aa-1/101] service ubr 100000
Related commands
service cbr
service vbr-nrt
service vbr-rt
service vbr-nrt
Use service vbr-nrt to set the PVC service type to VBR-NRT and set the related parameters.
Use undo service to restore the default.
Syntax
service vbr-nrt output-pcr output-scr output-mbs
undo service
Default
The service type of a PVC is UBR. The peak output rate of ATM cells equals the maximum
bandwidth of the interface to which the PVC belongs.
Views
PVC view
PVC view in a PVC-group
Predefined user roles
network-admin
Parameters
output-pcr: Specifies the peak output rate of ATM cells in kbps. For more information about the value
range, see Table 47.