H3C MSR810 - Pppoe-Server Access-Delay; Pppoe-Server Access-Line-ID Bas-Info

73
If the second verification still fails, the PPPoE server tears down the link.
NCP negotiation starts after the MRU verification succeeds.
Examples
# Enable MRU verification for PPPoE and set the minimum MRU to 1200 bytes on Virtual-Template
10.
<Sysname> system-view
[Sysname] interface virtual-template 10
[Sysname-Virtual-Template10] ppp lcp echo mru verify minimum 1200
pppoe-server access-delay
Use pppoe-server access-delay to set the response delay time on an interface.
Use undo pppoe-server access-delay to restore the default.
Syntax
pppoe-server access-delay delay-time
undo pppoe-server access-delay
Default
No response delay time is set on an interface.
Views
Layer 3 Ethernet interface/subinterface view
Layer 3 virtual Ethernet interface/subinterface view
VLAN interface view
Layer 3 aggregate interface/subinterface view
VE-L3VPN interface/subinterface view
EFM interface/subinterface view
Predefined user roles
network-admin
Parameters
delay-time: Specifies the response delay time, in the range of 10 to 25500 milliseconds.
Usage guidelines
The system responds to the first packet of a PPP connection on the interface after the configured
delay time elapses.
Examples
# Set the response delay time to 100 milliseconds on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] pppoe-server access-delay 100
pppoe-server access-line-id bas-info
Use pppoe-server access-line-id bas-info to configure the nas-port-id attribute to automatically
include BAS information on an interface.