H3C MSR810 - Dialer Disconnect; Dialer Flow-Interval

293
[Sysname-Serial2/1/0] dialer circular-group 1
[Sysname-Serial2/1/0] quit
[Sysname] interface serial 2/1/1
[Sysname-Serial2/1/1] dialer circular-group 1
Related commands
dialer circular enable
dialer priority
interface dialer
dialer disconnect
Use dialer disconnect to disconnect dialup links on an interface.
Syntax
dialer disconnect [ interface interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
Parameters
interface interface-type interface-number: Specifies an interface by its type and number. If you do
not specify an interface, this command disconnects dialup links on all interfaces.
Examples
# Disconnect dialup links on Dialer 0.
<Sysname> dialer disconnect interface dialer0
dialer flow-interval
Use dialer flow-interval to set the interval for DDR to collect traffic statistics.
Use undo dialer flow-interval to restore the default.
Syntax
dialer flow-interval interval
undo dialer flow-interval
Default
The interval for DDR to collect traffic statistics is 20 seconds.
Views
System view
Predefined user roles
network-admin
Parameters
interval: Specifies the interval for DDR to collect traffic statistics, in the range of 1 to 1500 seconds.