H3C MSR810 - Display Fr Ipv6 Map

326
Parameters
interface interface-type interface-number: Specifies an interface by its type and number. It can be a
main interface or subinterface. If you specify a main interface, this command displays statistics for
the main interface and its subinterfaces. If you specify a s ubinterface, this command displays
statistics for the subinterface. If you do not specify an interface, this command displays statistics for
all interfaces.
Usage guidelines
You can determine whether Frame Relay InARP is operating correctly based on the output from this
command.
Examples
# Display statistics for Frame Relay InARP packets.
<Sysname> display fr inarp
Frame relay InARP statistics for interface Serial2/1/0 (DTE)
Recvd InARP request Sent InARP reply Sent InARP request Recvd InARP reply
0 0 1 1
Table 62 Command output
Field
Description
Recvd InARP request Number of received InARP requests.
Sent InARP reply Number of sent InARP replies.
Sent InARP request Number of sent InARP requests.
Recvd InARP reply Number of received InARP replies.
Related commands
fr inarp
display fr ipv6 map
Use display fr ipv6 map to display Frame Relay IPv6 address mapping.
Syntax
display fr ipv6 map [ static | dynamic ] [ interface interface-type interface-number
[ dlci dlci-number ] ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
static: Specifies static address mapping.
dynamic: Specifies dynamic address mapping.
interface interface-type interface-number: Specifies an interface by its type and number. It can be a
main interface or subinterface. If you specify a main interface, this command displays IPv6 address
mapping for the main interface and its subinterfaces. If you specify a subinterface, this command
displays IPv6 address mapping for the subinterface. If you do not specify an interface, this command
displays IPv6 address mapping for all interfaces.