84
• Limit on an interface.
• Limit on a card. (Distributed devices in standalone.)
• Limit on a device. (Centralized devices in standalone mode.)
New maximum number settings only apply to subsequently established PPPoE sessions.
Examples
# Set the maximum number of PPPoE sessions for a VLAN on GigabitEthernet 1/0/1.1 to 50.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1.1
[Sysname-GigabitEthernet1/0/1.1] pppoe-server session-limit per-vlan 50
Related commands
pppoe-server sessions limit
pppoe-server sessions limit per-mac
pppoe-server sessions limit total
pppoe-server session-limit total
Use pppoe-server session-limit total to set the maximum number of PPPoE sessions on a device.
Use undo pppoe-server session-limit total to restore the default.
Syntax
Centralized devices in standalone mode:
pppoe-server session-limit total number
undo pppoe-server session-limit total
Distributed devices in standalone mode:
pppoe-server session-limit slot slot-number total number
undo pppoe-server session-limit slot slot-number total
Default
The number of PPPoE sessions on a device is not limited. (Centralized devices in standalone mode.)
The number of PPPoE sessions on a card is not limited. (Distributed devices in standalone.)
Views
System view
Predefined user roles
network-admin
Parameters
number: Specifies the maximum number of PPPoE sessions on a device, in the range of 1 to 65534.
slot slot-number: Specifies a card by its slot number. (Distributed devices in standalone mode.)
Usage guidelines
PPPoE can establish a session when none of the following limits are reached:
• Limit for a user on an interface.
• Limit for a VLAN on an interface.
• Limit on an interface.
To Next Page
Loading...
