H3C MSR810 - Ip Pool

10
Default
IP address negotiation is disabled on an interface.
Views
Interface view
Predefined user roles
network-admin
Usage guidelines
If you execute the ip address ppp-negotiate and ip address commands multiple times, the most
recent configuration takes effect.
Examples
# Enable IP address negotiation on Serial 2/1/0.
<Sysname> system-view
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] ip address ppp-negotiate
Related commands
ip address (Layer 3—IP Services Command Reference)
remote address
ip pool
Use ip pool to configure a PPP address pool.
Use undo ip pool to remove a PPP address pool or an IP address range of the PPP address pool.
Syntax
ip pool pool-name start-ip-address [ end-ip-address ] [ group group-name ]
undo ip pool pool-name [ start-ip-address [ end-ip-address ] ]
Default
No PPP address pool is configured.
Views
System view
Predefined user roles
network-admin
Parameters
pool-name: Specifies a name for the PPP address pool to be created, a case-sensitive string of 1 to
31 characters.
start-ip-address [ end-ip-address ]: Specifies an IP address range. If you do not specify
the end-ip-address argument, the PPP address pool has only the start IP address.
group group-name: Specifies a group by its name to which the PPP address pool belongs. The
group name is a case-sensitive string of 1 to 31 characters. If you do not specify this option, the
group name is default (the default group).
Usage guidelines
The system supports multiple address spaces that each correspond to a VPN instance. The same IP
addresses can exist in different address spaces.