H3C MSR810 - Dialer Bundle Enable; Dialer Bundle-Member

288
Parameters
text: Specifies the interface description, a case-sensitive string of 1 to 255 characters.
Examples
# Set the description of Dialer 1 to dialer-intf.
<Sysname> system-view
[Sysname] interface dialer 1
[Sysname-Dialer1] description dialer-intf
dialer bundle enable
Use dialer bundle enable to enable bundle DDR on a dialer interface.
Use undo dialer bundle enable to disable bundle DDR on a dialer interface.
Syntax
dialer bundle enable
undo dialer bundle enable
Default
Bundle DDR is disabled on a dialer interface.
Views
Dialer interface view
Predefined user roles
network-admin
Usage guidelines
DDR includes traditional DDR and bundle DDR.
Before using bundle DDR, use this command to enable bundle DDR on a dialer interface. Then
assign physical interfaces to the corresponding dialer bundle by using the dialer bundle-member
command. To enable bundle DDR to receive calls, configure the dialer peer-name command on the
dialer interface.
After you configure this command on a dialer interface already enabled with traditional DDR, the
system clears the original traditional DDR settings.
The undo dialer bundle enable command clears all bundle DDR settings on the dialer interface.
Examples
# Enable bundle DDR on Dialer 1.
<Sysname> system-view
[Sysname] interface dialer 1
[Sysname-Dialer1] dialer bundle enable
Related commands
dialer bundle-member
dialer circular enable
dialer peer-name
dialer bundle-member
Use dialer bundle-member to assign a physical interface to a dialer bundle in bundle DDR.