H3C MSR810 - Ip Address Ppp-Negotiate

9
Received:
Compressed/Error/Total: 0/0/0 packets
Sent:
Compressed/Total: 0/0 packets
Sent/Saved/Total: 0/0/0 bytes
Packet-based compression ratio: 0%
Byte-based compression ratio: 0%
Connections:
Rx/Tx: 16/16
Five-Minute-Miss: 0 (Misses/5Mins)
Max-Miss: 0
Table 4 Command output
Field
Description
Received:
Compressed/Error/Total
Statistics for received packets:
• Compressed—Number of compressed packets.
• Error—Number of error packets.
• Total—Total number of received packets.
Sent:
Compressed/Total
Sent/Saved/Total
Packet-based compression ratio
Byte-based compression ratio
Statistics for sent packets:
• Compressed—Number of compressed packets.
• Total—Total number of sent packets.
• Sent—Bytes of sent packets.
• Saved—Bytes of saved packets.
• Total—Total bytes to be sent if packets are not compressed.
• Packet-based compression ratio—Ratio of compressed
packets to the total sent packets.
• Byte-based compression ratio—Ratio of saved bytes to the
total sent bytes.
Connections:
Rx/Tx
Five-Minute-Miss
Max-Miss
Number of connections.
• Rx—Number of connections that the receiver can decompress.
• Tx—Number of connections that the sender can compress.
• Five-Minute-Miss—Number of search failures within the last 5
minutes.
• Max-Miss—Maximum number of search failures within 5
minutes.
Related commands
ppp compression iphc enable
reset ppp compression iphc
ip address ppp-negotiate
Use ip address ppp-negotiate to enable IP address negotiation on an interface, so that the
interface can accept the IP address allocated by the server.
Use undo ip address ppp-negotiate to restore the default.
Syntax
ip address ppp-negotiate
undo ip address ppp-negotiate