59
You can configure the following parameters for a VT interface:
• Local IP address and the peer IP address (or address pool).
• ppp mp-commands.
Examples
# Associate username user 1 with Virtual-Template 1, and set the IP address of the VT interface to
202.38.60.1/24.
<Sysname> system-view
[Sysname] ppp mp user user1 bind virtual-template 1
[Sysname] interface virtual-template 1
[Sysname-Virtual-Template1] ip address 202.38.60.1 255.255.255.0
Related commands
ppp mp
ppp mp virtual-template
Use ppp mp virtual-template to bind an interface to a VT interface and enable MP for the interface.
Use undo ppp mp to restore the default.
Syntax
ppp mp virtual-template number
undo ppp mp
Default
An interface is enabled with PPP.
Views
Interface view
Predefined user roles
network-admin
Parameters
number: Specifies a VT interface by its number.
The following matrix shows the value ranges for the number argument:
MSR810/810-W/810-W-DB/810-LM/810-W-LM/810-10-PoE/810-LM-HK/810-W-LM-H
K/810-LMS/810-LUS
0 to 1023
MSR2600-10-X1 0 to 1023
MSR 2630 0 to 1023
MSR3600-28/3600-51 0 to 1023
MSR3600-28-SI/3600-51-SI 0 to 1023
MSR 3610 0 to 1023
MSR3610-X1/3610-X1-DP/3610-X1-DC/3610-X1-DP-DC 0 to 2047
MSR 3620/3620-DP/3640/3660 0 to 2047
MSR5620/5660/5680 0 to 4095
To Next Page
Loading...
