EasyManua.ls Logo

H3C MSR810 - Display Interface Virtual-Access

H3C MSR810
389 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
39
Field
Description
Protocol
Line protocol state:
UPThe line protocol is up.
DOWNThe line protocol is down.
UP(s)The line protocol is up, but the physical link is an
on-demand link or is not present.
Primary IP Primary IP address of the interface.
Description
Interface description configured by using the
description
command. If you do not specify the
description
keyword,
the
display interface
brief
command displays a maximum of 27
characters of the description. If you specify the
description
keyword, the command displays the complete description.
Cause
Causes for the physical state of the interface to be Down:
Not connectedNo physical connection exists (possibly
because the network cable is disconnected or faulty).
AdministrativelyThe interface was shut down with
the shutdown command. To restore the physical state of the
interface, use the undo shutdown command.
Related commands
reset counters interface mp-group
display interface virtual-access
Use display interface virtual-access to display information about VA interfaces.
Syntax
display interface [ virtual-access [ interface-number ] ] [ brief [ description | down ] ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface-number: Specifies a VA interface by its number.
brief: Displays brief interface information. If you do not specify this keyword, the command displays
detailed interface information.
description: Displays interface description information. This keyword does not apply to VA
interfaces because VA interfaces do not support description configuration.
down: Displays information about interfaces in physically down state and the causes. If you do not
specify this keyword, the command displays information about all interfaces.
Usage guidelines
If you do not specify the virtual-access keyword, the command displays information about all
interfaces on the device.
If you specify the virtual-access keyword without the interface-number argument, the command
displays information about all VA interfaces.

Table of Contents

Other manuals for H3C MSR810

Related product manuals