38
Hold timer Interval at which the interface sends keepalive packets.
retry times
Keepalive retry limit.
The interface determines that its peer has been down if it does not
receive a keepalive response when the keepalive retry limit is
reached.
Internet protocol processing The interface cannot process IP packets currently.
Internet address: 192.168.1.200/24
(primary)
Primary IP address of the interface.
LCP initial LCP negotiation is complete.
Physical Physical type of the interface.
baudrate Baud rate of the interface.
Output queue - Urgent queuing:
Size/Length/Discards 0/100/0
Output queue - Protocol queuing:
Size/Length/Discards 0/500/0
Output queue - FIFO queuing:
Size/Length/Discards 0/75/0
Traffic statistics of the interface output queues.
Last clearing of counters: Never
Last time when statistics on the interface were cleared.
Never
indicates that statistics on the interface were never cleared.
Last 300 seconds input rate: 0
bytes/sec, 0 packets/sec
Last 300 seconds output rate: 0
bytes/sec, 0 packets/sec
Average rate of input packets and output packets in the last 300
seconds.
Input: 0 packets, 0 bytes, 0 drops
Total number of inbound packets of the interface (in the number of
packets and in bytes), and the number of dropped incoming
packets.
Output: 0 packets, 0 bytes, 0 drops
Total number of outbound packets of the interface (in the number of
packets and in bytes), and the number of dropped outgoing
packets.
Brief information on interfaces in route
mode
Brief information about Layer 3 interfaces.
Link: ADM - administratively down;
Stby - standby
Link status:
• ADM—The interface has been administratively shut down. To
recover its physical state, execute the undo shutdown
command.
• Stby—The interface is operating as a backup interface. To
see the primary interface, use the display interface-backup
state command in High Availability Command Reference.
Protocol: (s) - spoofing
Indicates the line protocol is UP, but the physical link is an
on-demand link or is not present.
Interface Abbreviated interface name.
Link
Physical link state of the interface:
• UP—The interface is physically up.
• DOWN—The interface is physically down.
• ADM—The interface has been administratively shut down. To
recover its physical state, use the undo shutdown command.
• Stby—The interface is a backup interface.
To Next Page
Loading...
