37
<Sysname> display interface mp-group 2/0/0
MP-group2/0/0
Current state: DOWN
Line protocol state: DOWN
Description: MP-group2/0/0 Interface
Bandwidth: 2048kbps
Maximum transmission unit: 1500
Hold timer: 10 seconds, retry times: 5
Internet address: 192.168.1.200/24 (primary)
Link layer protocol: PPP
LCP: initial
Physical: MP, baudrate: 2048000 bps
Output queue - Urgent queuing: Size/Length/Discards 0/100/0
Output queue - Protocol queuing: Size/Length/Discards 0/500/0
Output queue - FIFO queuing: Size/Length/Discards 0/75/0
Last clearing of counters: Never
Last 300 seconds input rate: 0 bytes/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 packets/sec
Input: 0 packets, 0 bytes, 0 drops
Output: 0 packets, 0 bytes, 0 drops
# Display brief information about MP-group 2/0/0.
<Sysname> display interface mp-group 12 brief
Brief information on interfaces in route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface Link Protocol Primary IP Description
MP2/0/0 DOWN DOWN --
# Display brief information about the MP-group interfaces in physically down state and the causes.
<Sysname> display interface mp-group brief down
Brief information on interfaces in route mode:
Link: ADM - administratively down; Stby - standby
Interface Link Cause
MP2/0/0 ADM Administratively
MP2/0/1 DOWN Not connected
Table 6 Command output
Current state
Physical and administrative states of the interface:
• DOWN (Administratively)—The interface was
administratively shut down with the shutdown command.
• DOWN—The interface is administratively up but physically
down (possibly because no physical link is present or the link
is faulty).
• UP—The interface is both administratively and physically up.
Line protocol state Data link layer state: UP or DOWN.
Description Interface description.
Bandwidth Expected bandwidth of the interface.
To Next Page
Loading...
