317
[Sysname] standby routing-group 1 rule ip 20.0.0.1 255.0.0.0
[Sysname] standby routing-group 1 rule ip 30.0.0.1 255.0.0.0
standby timer routing-disable
Use standby timer routing-disable to set the secondary link disconnection delay.
Use undo standby timer routing-disable to restore the default.
Syntax
standby timer routing-disable delay
undo standby timer routing-disable
Default
The secondary link disconnection delay is 20 seconds.
Views
Dialup interface view
Predefined user roles
network-admin
Parameters
delay: Specifies the secondary link disconnection delay in the range of 0 to 65535 seconds.
Examples
# Set the secondary link disconnection delay to 5 seconds on BRI 2/4/0.
<Sysname> system-view
[Sysname] interface bri 2/4/0
[Sysname-Bri2/4/0] standby timer routing-disable 5
timer-hold
Use timer-hold to set the keepalive interval.
Use undo timer-hold to restore the default.
Syntax
timer-hold seconds
undo timer-hold
Default
The keepalive interval is 10 seconds.
Views
Dialer interface view
Predefined user roles
network-admin
Parameters
seconds: Specifies the interval for sending keepalive packets, in the range of 0 to 32767 seconds.
The value 0 disables keepalive packet sending.
To Next Page
Loading...
