308
Internet protocol processing Network layer protocol state of the dialer interface.
Hold timer Interval for sending keepalive packets.
retry times
Maximum number of keepalive retransmission attempts. A link is
removed after the maximum number of retransmission attempts is
reached.
LCP: initial LCP initialization is complete.
Physical Physical interface type.
Output queue - Urgent queuing:
Size/Length/Discards
Statistics on the packets in the urgent output queue.
Output queue - Protocol
queuing: Size/Length/Discards
Statistics on the packets in the protocol output queue.
Output queue - FIFO queuing:
Size/Length/Discards
Statistics on the packets in the FIFO output queue.
Last clearing of counters: Never
Time when the
reset counters interface
command was last used to
clear the interface statistics. This field displays
Never
if the
reset
counters interface
command has never been used on the interface
since device startup.
Last 300 seconds input rate Input interface data rate during the latest 300 seconds.
Last 300 seconds output rate Output interface data rate during the latest 300 seconds.
Input: 0 packets, 0 bytes, 0
dropped
Statistics on the packets reaching the interface.
Output: 0 packets, 0 bytes, 0
dropped
Statistics on the packets sent through the interface.
Brief information on interface(s)
under route mode:
Brief information about Layer 3 interfaces.
Link: ADM - administratively
down; Stby - standby
Link status:
• ADM—The interface has been administratively shut down. To
recover its physical state, execute the undo shutdown command.
• Stby—The interface is operating as a standby interface. To display
the active interface, use the display interface-backup state
command (High Availability Command Reference).
Protocol: (s) - spoofing
If the data link layer protocol state of an interface is shown as UP, but its
link is an on-demand link or not present at all, its protocol attribute
includes the spoofing flag (an
s
in parentheses).
Interface Abbreviated interface name.
Link
Physical link state of the interface:
• UP—The interface is up.
• ADM—The interface has been administratively shut down. To bring
up the interface, execute the undo shutdown command.
• Stby—The interface is operating as a standby interface.
Protocol
Data link layer protocol state of the dialer interface:
• UP.
• DOWN.
• UP(s)—The interface is up, but its link is an on-demand link or not
present at all.
Main IP Primary IP address of the interface.
To Next Page
Loading...
