147
Last 300 seconds input rate: 0
bytes/sec, 0 bits/sec, 0
packets/sec
Last 300 seconds output rate: 0
bytes/sec, 0 bits/sec, 0
packets/sec
Average incoming and outgoing traffic rates on the interface in the last
300 seconds.
Input: 32 packets, 1842 bytes, 0
drops
Incoming traffic size in packets and bytes and the number of dropped
incoming packets on the interface.
Output: 27 packets, 1512 bytes, 0
drops
Outgoing traffic size in packets and bytes and the number of dropped
outgoing packets on the interface.
Brief information on interface(s)
under route mode
Brief information about Layer 3 interfaces.
Link: ADM - administratively down;
Stby - standby
Link status:
• ADM—The interface has been administratively shut down. To
recover its physical state, perform the undo shutdown
command.
• Stby—The interface is operating as a backup interface. To see
the primary interface, use the display interface-backup state
command.
Protocol: (s) – spoofing
If the data link layer protocol state of an interface is shown as UP, but
its link is an on-demand link or not present at all, the protocol attribute
includes the spoofing flag (an
s
in parentheses).
Interface Abbreviated interface name.
Link
Physical link state of the interface:
• UP—The interface is up.
• ADM—The interface has been administratively shut down. To
bring up the interface, perform the undo shutdown command.
Protocol
Date link layer protocol state of the interface:
• UP—The data link layer protocol state of the interface is up.
• DOWN—The data link layer protocol state of the interface is
down.
• UP(s)—The data link layer protocol state of the interface is shown
as UP, but its link is an on-demand link or not present at all.
Main IP
Main IP address of the interface. Two hyphens (--) indicate that no
main IP address is configured for the interface.
Description
Partial or complete interface description configured by using
the
description
command:
• If the description keyword is not specified for the display
interface brief command, this field displays only the first 27
characters of the interface description.
• If the description keyword is specified for the display interface
brief command, this field displays the complete interface
description.
Cause
Reason why a physical link is down. If the port has been shut down by
using the
shutdown
command, this field displays
Administratively
.
To restore the physical state of the interface, use the
undo shutdown
command.
Related commands
reset counters interface
To Next Page
Loading...
