7
Session timeout
Authorization time for the user, in seconds.
A hyphen (-) means that no authorization time is specified for the
user.
Time remained
Remaining time for the user to stay online, in seconds.
A hyphen (-) means that no authorization time is specified for the
user.
Byte remained
Remaining traffic for the user.
A hyphen (-) means that no authorization traffic is specified for the
user.
Redirect WebURL
Redirect Web URL address for the user.
A hyphen (-) means that no redirect Web URL address is specified
for the user.
User profile
Name of the authorized user profile. The hyphen (-) means that no
user profile is authorized.
The user profile has two states:
• active—The authorized user profile is successfully issued.
• inactive—The authorized user profile fails to be issued.
User group profile
Name of the authorized user group profile. The hyphen (-) means
that no user group profile is authorized.
The user group profile has two states:
• active—The authorized user group profile is successfully
issued.
• inactive—The authorized user group profile fails to be issued.
Inbound CAR Authorized inbound CARs, which contain the CIR and the PIR.
Outbound CAR Authorized outbound CARs, which contain the CIR and the PIR.
Global IP address
Global IP address of the user.
This field is displayed if NAT444 is used. For information about
NAT444, see Layer 3—IP Services Configuration Guide.
Port block
Port block of the user, from the start port to the end port.
This field is displayed if NAT444 is used.
IPv4 uplink packets/bytes Number of packets and bytes for IPv4 uplink traffic.
IPv4 downlink packets/bytes Number of packets and bytes for IPv4 downlink traffic.
IPv6 uplink packets/bytes Number of packets and bytes for IPv6 uplink traffic.
IPv6 downlink packets/bytes Number of packets and bytes for IPv6 downlink traffic.
ITA
ITA statistics.
ITA statistics are displayed after ITA is enabled.
If the
traffic-separate enable
command is configured, ITA
statistics are not included in flow statistics. For information about
ITA and the
traffic-separate enable
command, see Security
Configuration Guide.
Level-n uplink packets/bytes
downlink packets/bytes
Number of packets and bytes for uplink traffic at accounting level n.
The value for n depends on the
traffic level
command, and its
value range is 1 to 8.
Related commands
reset ppp access-user
To Next Page
Loading...
