EasyManua.ls Logo

H3C MSR810 - Page 213

H3C MSR810
389 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
201
Field
Description
Precedence
Priority of the IP packets carried by the PVC in the PVC-group:
DefaultDefault PVC. IP packets without a priority configured
are transmitted through the default PVC.
a-bLowest and highest priorities of the IP packets carried by
the PVC. The value range for a and b is 0 to 7. a is smaller
than b.
cPriority of the IP packets carried by the PVC, in the range of
0 to 7.
-No priority is configured for IP packets carried by the PVC.
Service-type
Service type:
CBRConstant bit rate.
UBRUnspecified bit rate.
VBR-NRTVariable bit rate-non real time.
VBR-RTVariable bit rate-real time.
Output-pcr Peak output rate of ATM cells.
CDVT Cell delay variation tolerance in microseconds.
Transmit-Priority Transmission priority.
OAM loopback interval Interval (in seconds) at which OAM F5 Loopback cells are sent.
OAM loopback retry interval
Interval (in seconds) at which OAM F5 Loopback retransmission
detection cells are sent.
OAM loopback retry count (up/down) Number of cells that are detected as up and down in OAM detection.
OAM AIS-RDI count (up/down)
Number of seconds that are detected as up in OAM AIS-RDI
detection. Number of cells that are detected as down in OAM
AIS-RDI detection.
Interface State
Name of the interface to which the PVC belongs, and the physical
and administrative states of the interface.
State of an interface (not a subinterface):
UPThe interface is both physically and administratively up.
DOWNThe interface is in either of the following states:
The interface is administratively up and physically down
(probably because no physical link is available or the link
has failed).
The interface is administratively down (shut down by using
the shutdown command).
State of a subinterface:
UPThe interface is administratively up. The parent interface
is both physically and administratively up.
DOWNThe interface or its parent interface was shut down by
using the shutdown command, or the parent interface is
physically down.
OAM State OAM protocol state:
UP
or
DOWN
.

Table of Contents

Other manuals for H3C MSR810

Related product manuals