207
<Sysname> display interface virtual-ethernet brief down
Brief information on interface(s) under bridge mode:
Link: ADM - administratively down; Stby - standby
Interface Link Cause
VE2/4/1 DOWN Not connected
Table 44 Command output
Current state
Physical state of the interface:
• Administratively DOWN—The interface was shut down by using
the shutdown command.
• DOWN—The interface is administratively up but physically down
(probably because no physical link is available or the link has
failed).
• UP—The interface is both administratively and physically up.
Line protocol state Link layer protocol state of the interface:
UP
or
DOWN
.
Internet protocol processing Internet protocol processing state of the interface.
IP Packet Frame Type
Encapsulation format for IPv4 packets.
PKTFMT_ETHNT_2
stands for
Ethernet II frame format.
IPv6 Packet Frame Type Encapsulation format for IPv6 packets.
Hardware Address MAC address of the interface.
Last clearing of counters: Never
Time when the
reset counters interface
command was last used to
clear the interface statistics.
Never
indicates the
reset counters
interface
command has never been used on the interface after the
device has started up.
Last 300 seconds input rate Average packet input rate over the last 300 seconds.
Last 300 seconds output rate Average packet output rate over the last 300 seconds.
Input
Input packet statistics:
• packets—Number of packets.
• bytes—Total bytes.
• drops—Number of dropped packets.
Output
Output packet statistics:
• packets—Number of packets.
• bytes—Total bytes.
• drops—Number of dropped packets.
Brief information on interface(s)
under route mode
Brief information about the Layer 3 interface.
Link: ADM - administratively
down; Stby - standby
Link layer state of the interface:
• ADM—The interface was shut down by the network administrator.
To recover its physical layer state, use the undo shutdown
command.
• Stby—The interface is a standby interface. You can use
the display interface-backup state command to check the
corresponding primary interface.
Protocol: (s) - spoofing
If the protocol attribute of an interface includes the spoofing flag (an
s
in
parentheses), the data link layer protocol state of the interface is shown
as UP, but its link is an on-demand link or not present at all.
Interface Abbreviation of the interface name.
To Next Page
Loading...
