243
Mobile Country Code
(MCC)
The MCC is displayed if the modem has found a mobile network.
Mobile Network Code
(MNC)
The MNC is displayed if the modem is successfully registered with a mobile
network.
Location Area Code (LAC)
The LAC is displayed if the modem is successfully registered with a mobile
network.
Cell ID
The Cell ID is displayed if the modem is successfully registered with a mobile
network.
Current Band
Current band selection mode:
• GSM.
• WCDMA.
• A N Y.
• AUTO.
Current RSSI
Current RSSI:
• An RSSI value in the range of –110 dBm to –51 dBm.
• Unknown—No signal. The cellular interface is unavailable.
PIN Verification
PIN authentication status:
• Disabled.
• Enabled.
PIN Status
PIN status:
• Ready—The SIM card is ready.
• PIN Requirement—Requires you to execute the pin verify command to
enter the PIN for PIN verification.
• PUK Requirement—Requires you to execute the pin unlock command
to unlock the SIM or UIM card.
Number of Retries
remaining
Remaining retries available for entering the PIN or PUK.
SIM Status
SIM card status:
• OK—The SIM card is normal.
• Network Reject—The SIM card is denied access to the network. The
cellular interface is not available.
• Not Insert—The SIM card is absent. The cellular interface is not
available.
# Display call connection information for Cellular 2/4/0 (TD-SCDMA network).
<Sysname> display cellular 2/4/0
Cellular2/4/0:
Hardware Information:
Model: ET128
Modem Firmware Version: 11.101.01.08.00
Hardware Version: CS31TCPU
International Mobile Subscriber Identity (IMSI): 460079011105842
International Mobile Equipment Identity (IMEI): 860039002369111
Factory Serial Number (FSN): GQ4CAB1942911350
Modem Status: Online
Profile Information:
Profile 1: Active
PDP Type: IPv4
To Next Page
Loading...
