EasyManua.ls Logo

H3C MSR810 - Page 257

H3C MSR810
389 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
245
Field
Description
Packet Session Status
PDP status:
• Active—The modem is transmitting data through PPP.
• Inactive—The modem is physically down.
Current Service Status
Service status of the modem:
• Service available—The modem is providing services correctly.
• Emergency—The modem is providing limited services. The cellular
interface is not available.
• No service—The modem cannot provide services. The cellular
interface is not available.
• Low power—The modem is in low power mode. The cellular interface is
not available.
Network Selection Mode
Network selection mode:
• Manual.
• Automatic.
Network Connection Mode
Network connection mode:
• WCDMA only—Connected to the WCDMA network only.
• WCDMA precedence—Connected to the WCDMA network with
preference.
• GSM only—Connected to the GSM network only.
• GSM precedence—Connected to the GSM network with preference.
Current Network
Connection
Current network:
• No Service.
• GSM.
• GPRS.
• EDGE.
• TD-SCDMA.
• HSDPA.
• Unknown.
Downstream Bandwidth Downstream bandwidth, in bps.
Radio Information Radio communication information.
Current RSSI
Current RSSI:
• An RSSI value in the range of –110 dBm and –51 dBm.
• Unknown—No signal. The cellular interface is unavailable.
PIN Verification
PIN authentication status:
• Disabled.
• Enabled.
PIN Status
PIN status:
• Ready—The SIM card is ready.
• PIN Requirement—Requires you to execute the pin verify command to
enter the PIN for PIN verification.
• PUK Requirement—Requires you to execute the pin unlock command
to unlock the SIM or UIM card.
Number of Retries
remaining
Remaining retries available for entering the PIN or PUK.

Table of Contents