EasyManua.ls Logo

H3C MSR810 - Page 53

H3C MSR810
389 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
41
Field
Description
retry times
Keepalive retry limit.
The interface determines that its peer has been down if it does not
receive a keepalive response when the keepalive retry limit is
reached.
Internet protocol processing: Disabled The interface cannot process IP packets currently.
Internet address: 122.1.1.1/24
(primary)
Primary IP address of the interface.
LCP: opened, MP: opened, IPCP:
opened
The PPP connection has been successfully established.
Physical Physical type of the interface.
Main interface VT interface associated with the VA interface.
Output queue - Urgent queuing:
Size/Length/Discards 0/100/0
Output queue - Protocol queuing:
Size/Length/Discards 0/500/0
Output queue - FIFO queuing:
Size/Length/Discards 0/75/0
Traffic statistics of the interface output queues.
Last clearing of counters: Never
Last time when statistics on the interface were cleared.
Never
indicates that statistics on the interface were never cleared.
Last 300 seconds input rate: 0
bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0
bytes/sec, 0 bits/sec, 0 packets/sec
Average rate of input packets and output packets in the last 300
seconds.
Input: 2 packets, 24 bytes, 0 drops
Total number of inbound packets of the interface (in the number of
packets and in bytes), and the number of packets dropped among
the inbound packets.
Output: 2 packets, 24 bytes, 0 drops
Total number of outbound packets of the interface (in the number of
packets and in bytes), and the number of packets dropped among
the outbound packets.
Brief information on interfaces in route
mode
Brief information about Layer 3 interfaces.
Link: ADM - administratively down;
Stby - standby
Link status:
ADMThe interface has been administratively shut down. To
recover its physical state, execute the undo shutdown
command.
StbyThe interface is a backup interface. To see the primary
interface, use the display interface-backup state command
in High Availability Command Reference.
Protocol: (s) - spoofing
Indicates the line protocol is UP, but the physical link is an
on-demand link or is not present.
Interface Abbreviated interface name.
Link
Physical link state of the interface:
UPThe interface is physically up.
DOWNThe interface is physically down.

Table of Contents

Other manuals for H3C MSR810

Related product manuals