H3C MSR810 - Page 79

67
display pppoe-server session packet [ interface interface-type interface-number ]
Distributed devices in standalone mode:
display pppoe-server session packet { slot slot-number | interface interface-type
interface-number }
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface interface-type interface-number: Specifies an interface by its type and number. If you do
not specify an interface for centralized devices in standalone mode, the command displays packet
statistics for PPPoE sessions on all interfaces.
slot slot-number: Specifies a card by its slot number. If you do not specify a card, the command
displays packet statistics for PPPoE sessions on all cards. (Distributed devices in standalone mode.)
Examples
# Display packet statistics for PPPoE sessions on GigabitEthernet 1/0/1.
<Sysname> display pppoe-server session packet interface gigabitethernet 1/0/1
Total PPPoE sessions: 2
Ethernet interface: GE1/0/1 Session ID: 1
InPackets: 37 OutPackets: 38
InBytes: 390 OutBytes: 406
InDrops: 0 OutDrops: 0
Ethernet interface: GE1/0/1 Session ID: 2
InPackets: 67 OutPackets: 48
InBytes: 490 OutBytes: 806
InDrops: 1 OutDrops: 2
Table 10 Command output
Field
Description
Ethernet interface Interface where the PPPoE session is present.
Session ID PPPoE session ID.
InPackets Number of packets received.
OutPackets Number of packets transmitted.
InBytes Number of bytes received.
OutBytes Number of bytes transmitted.
InDrops Number of discarded incoming packets.
OutDrops Number of discarded outgoing packets.
Related commands
display interface virtual-access