Contents
24
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
4 DIN/ISO programming.................................................................................................................231
4.1 Programming in ISO Mode............................................................................................................... 232
Geometry and machining commands..................................................................................................232
Contour programming.......................................................................................................................... 234
NC blocks of the DIN/ISO program..................................................................................................... 236
Creating, editing and deleting NC blocks............................................................................................ 237
Address parameters.............................................................................................................................238
Machining cycles..................................................................................................................................240
Subprograms and expert programs..................................................................................................... 241
NC program interpretation................................................................................................................... 241
DIN/ISO programs of predecessor controls........................................................................................ 242
Geometry menu item.......................................................................................................................... 244
Machining menu item.......................................................................................................................... 244
4.2 Definition of workpiece blank.......................................................................................................... 245
Chuck part bar or tube G20-Geo..........................................................................................................245
Casting G21-Geo.................................................................................................................................. 245
4.3 Basic elements of turning contour...................................................................................................246
Starting point of turning contour G0–Geo........................................................................................... 246
Machining attributes for form elements.............................................................................................. 246
Line segment in a contour G1–Geo.................................................................................................... 247
Circular arc of turning contour G2-/G3-Geo......................................................................................... 249
Circular arc of turning contour G12-/G13-Geo......................................................................................251
4.4 Form elements of turning contour...................................................................................................253
Recess (standard) G22–Geo................................................................................................................ 253
Recess (general) G23–Geo.................................................................................................................. 255
Thread with undercut G24–Geo...........................................................................................................257
Undercut G25–Geo.............................................................................................................................. 258
Thread (standard) G34–Geo................................................................................................................. 261
Thread (general) G37–Geo................................................................................................................... 262
Bore hole (centric) G49–Geo............................................................................................................... 265
4.5 Attributes for contour description....................................................................................................266
Feed reduction G38-Geo......................................................................................................................266
Attributes for superimposed elements G39-Geo.................................................................................267
Separation point G44........................................................................................................................... 268
Oversize G52-Geo................................................................................................................................ 268
Feed per revolution G95-Geo...............................................................................................................269
Additive correction G149-Geo.............................................................................................................. 270
4.6 C-axis contours – fundamentals.......................................................................................................271
Position of milling contours................................................................................................................. 271
Circular pattern with circular slots....................................................................................................... 274
To Next Page
Loading...
