HEIDENHAIN CNC PILOT 640 - Page 25

Contents
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
25
4.7 Front/Rear face contours...................................................................................................................277
Starting point of front/rear face contour G100-Geo.............................................................................277
Line segment in front/rear face contour G101-Geo............................................................................. 277
Circular arc in front/rear face contour G102-/G103-Geo.......................................................................278
Bore hole on front/rear face G300-Geo............................................................................................... 279
Linear slot on front/rear face G301-Geo.............................................................................................. 279
Circular slot on front/rear face G302-/G303-Geo................................................................................. 280
Full circle on front/rear face G304-Geo................................................................................................280
Rectangle on front/rear face G305-Geo...............................................................................................281
Polygon on front/rear face G307-Geo.................................................................................................. 281
Linear pattern on front/rear face G401-Geo......................................................................................... 282
Circular pattern on front/rear face G402-Geo...................................................................................... 283
4.8 Lateral surface contours....................................................................................................................284
Starting point of lateral surface contour G110-Geo..............................................................................284
Line segment in a lateral surface contour G111-Geo...........................................................................284
Circular arc in lateral surface contour G112-/G113-Geo........................................................................285
Hole on lateral surface G310-Geo........................................................................................................286
Linear slot on lateral surface G311-Geo...............................................................................................286
Circular slot on lateral surface G312-/G313-Geo..................................................................................287
Full circle on lateral surface G314-Geo................................................................................................ 287
Rectangle, surface G315-Geo.............................................................................................................. 288
Polygon on lateral surface G317-Geo...................................................................................................288
Linear pattern on lateral surface G411-Geo......................................................................................... 289
Circular pattern on lateral surface G412-Geo.......................................................................................290
4.9 Tool positioning..................................................................................................................................291
Rapid traverse G0................................................................................................................................ 291
Rapid traverse in machine coordinates G701...................................................................................... 291
Tool change point G14......................................................................................................................... 292
Defining the Tool change pointG140....................................................................................................292
4.10 Linear and circular movements........................................................................................................ 293
Linear movement G1........................................................................................................................... 293
Circular arc ccw G2/G3........................................................................................................................294
Circular arc ccw G12/G13.................................................................................................................... 295
4.11 Feed rate, shaft speed....................................................................................................................... 296
Speed limitation G26........................................................................................................................... 296
Reduce rapid traverse G48.................................................................................................................. 296
Interrupted feed G64............................................................................................................................297
Feed per tooth Gx93............................................................................................................................298
Constant feed G94 (feed per minute)..................................................................................................298
Feed per revolution Gx95.................................................................................................................... 299
Constant cutting speed Gx96.............................................................................................................. 300
Spindle speed Gx97.............................................................................................................................301