DIN/ISO programming | C-axis contours – fundamentals
4
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
275
Slot centerline as reference and original position
Programming:
Pattern center = center of curvature
Pattern radius = curvature radius
Original position
These commands arrange all slot at the same position.
Example: Slot centerline as reference, original position
N.. G402 Q4 K30 A0 XK0 YK0 H1
Circular pattern, original position
N.. G303 I0 J0 R15 A-20 W20 B3 P1
Circular slot
Center of curvature as reference and normal position
Programming:
Pattern center <> center of curvature
Pattern radius = curvature radius
Normal position
These commands arrange the slots at the distance of the pattern
radius plus curvature radius about the pattern center.
Example: Center of curvature as reference, normal position
N.. G402 Q4 K30 A0 XK5 YK5 H0
Circular pattern, normal position
N.. G303 I0 J0 R15 A-20 W20 B3 P1
Circular slot
To Next Page
Loading...
