DIN/ISO programming | C-axis contours – fundamentals
4
276
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
Center of curvature as reference and original position
Programming:
Pattern center <> center of curvature
Pattern radius = curvature radius
Original position
These commands arrange the slots at the distance of the pattern
radius plus curvature radius about the pattern center while
keeping the starting and ending angle.
Example: Center of curvature as reference and original position
N.. G402 Q4 K30 A0 XK5 YK5 H1
Circular pattern, original position
N.. G303 I0 J0 R15 A-20 W20 B3 P1
Circular slot
To Next Page
Loading...
