DIN/ISO programming | Programming variables
4
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
465
#wn(I)
Position of tool tip center in X
#wn(J)
Position of tool tip center in Y
#wn(K)
Position of tool tip center in Z
#wn(ZE)
Length of the tool in the current insert
position: Distance between tool tip and slide
reference point Z
#wn(XE)
Length of the tool in the current insert
position: Distance between tool tip and slide
reference point X
#wn(YE)
Length of the tool in the current insert
position: Distance between tool tip and slide
reference point Y
#wn(DN)
Diameter of drilling and milling tools
#wn(HW)
Principal angle in the normalized system (0° to
360°)
#wn(NW)
Secondary angle in the normalized system (0°
to 360°)
#wn(EW)
Tool angle
#wn(SW)
Point angle
#wn(AW)
0: No driven tool
1: Driven tool
#wn(MD)
Direction of rotation:
3: M3
4: M4
#wn(CW)
Tilting plane angle
#wn(BW)
Angular offset
#wn(WTL)
Orientation
#wn(AC)
Cutting-edge insert angle
#wn(ZS)
Maximum cutting depth
#wn(GH)
Thread pitch
#wn(NE)
Number of secondary cutting edges
#wn(NS)
Number of the secondary cutting edge
#wn(FP)
Tool type:
0 = normal tool
1 = master tools
2 = secondary cutting edge
#wn(Q)
Number of tool spindle
#wn(AS)
Execution left/right
#wn(X)
Setting dimension of holder in X
#wn(Z)
Setting dimension of holder in Z
#wn(Y)
Setting dimension of holder in Y
#wn(DX)
Compensation in X
#wn(DY)
Compensation in Y
To Next Page
Loading...
