HEIDENHAIN CNC PILOT 640 - Page 626

TURN PLUS | Automatic working plan generation (AWG) submode
7
626
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
Machining sequence Finishing
Main mach.
operation
Anc. mach.
operation
Machining location
Design
Finishing
Contour analysis: Dividing the contour into
areas for outside and inside machining
Sequence: First outside, then inside machining
Machining parameter: 5 – Finishing
Contour parallel
– Outside/inside machining
Contour parallel Extnl.
Outside machining
Contour parallel Internal
Inside machining
Machining sequence Recessing
Main mach.
operation
Anc. mach.
operation
Machining location
Design
Recessing
Contour analysis:
Without previous roughing – the complete
contour, including recess areas (undefined
recesses), is machined
With previous roughing – Recess areas
(undefined recesses) are determined and
machined according to the inward copying
angle EKW
Sequence: First outside, then inside machining
Machining parameter: 1 Global parameters for
finished parts
All
– Radial/axial machining – Extnl. and Internal
Longitudinal
machining
Extnl.
Radial machining – Extnl.
Longitudinal
machining
Internal
Radial machining – Internal
Transverse
machining
Outside/front
Axial machining – Extnl.
Transverse
machining
Inside/front
Axial machining – Internal
Recessing and Contour recessing are used alternatively.