Overview of G codes | Overview of G commands in the CONTOUR section
10
676
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
G commands for C-axis contours
Overlapping contours Page
G308-Geo Start pocket/isl.
Page 271
G309-Geo End of pocket/island
Page 271
Front and rear face contours Page
G100-Geo Start point
Page 277
G101-Geo Linear face
Page 277
G102-Geo Circ. arc face cw
Page 278
G103-Geo Circ. arc face cw
Page 278
G300-Geo Hole, face
Page 279
G301-Geo Linear slot, face
Page 340
G302-Geo Slot cw, face
Page 340
G303-Geo Slot ccw, face
Page 340
G304-Geo Full circle, face
Page 341
G305-Geo Rectangle, face
Page 341
G307-Geo Polygon on front face
Page 342
G401-Geo Pattern linear face
Page 282
G402-Geo Pattern circ. face
Page 283
Lateral surface contours Page
G110-Geo Start point
Page 284
G111-Geo Surface linear
Page 284
G112-Geo Circ.arc surface ccw
Page 285
G113-Geo Circ.arc surface ccw
Page 285
G310-Geo Hole, surface
Page 286
G311-Geo Linear slot, surf.
Page 286
G312-Geo Slot cw, surface
Page 287
G313-Geo Slot ccw, surface
Page 287
G314-Geo Full circle, surf.
Page 287
G315-Geo Rectangle, surface
Page 288
G317-Geo Polygon on lateral surface
Page 288
G411-Geo Pattern linear surf
Page 289
G412-Geo Pattern circ. surf.
Page 290
To Next Page
Loading...
