smart.Turn units | Units – smart.Turn units
2
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
83
Global form
This form contains parameters that were defined as default values
in the start unit. You can edit these parameters in the machining
units.
Parameters:
G14: Tool change point
No axis
0: Simultaneously
1: First X, then Z
2: First Z, then X
3: Only X
4: Only Z
5: Only Y (machine-dependent)
6: Simultaneous w/ Y (machine-dependent)
CLT: Coolant
0: Without
1: Coolant 1 on
2: Coolant 2 on
G47: Safety clearance – indicates the distance to the current
workpiece blank along which the tool is not moved at rapid
traverse
SCK: Safety clearance in infeed direction during drilling and
milling operations
SCI: Safety clearance in the machining plane during drilling and
milling operations
G60: Protection zone – protection zone monitoring during
drilling
0: Active
1: Inactive
Programming notes:
If, on controls without Y axis, you set G14 to the
default setting 5: Only Y or 6: Simultaneous w/ Y ,
the control will use No axis or 0: Simultaneously.
The units G840 "Contour milling, figures" and G84X
"Pocket milling, figures" additionally provide the
parameter Return plane RB on the Global form.
To Next Page
Loading...
