smart.Turn units | Units – smart.Turn units
2
84
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
AppDep form
Positions and variants of the approach and departure movements
are defined in this form.
Influence the approach strategy with the following parameters.
Approach:
APP: Type of approach
No axis – switch off the approach function
0: Simultaneously – X and Z axis approach diagonally
1: First X, then Z
2: First Z, then X
3: Only X
4: Only Z
XS, ZS: Approach position X and Z – position of the tool tip
before cycle call
Additionally with C-axis operations:
CS: Approach position C – C-axis position that is approached
before cycle call with G110
Approach with Y axis:
APP: Type of approach
No axis – switch off the approach function
0: Simultaneously – X and Z axis approach diagonally
1: First X, then Z
2: First Z, then X
3: Only X
4: Only Z
5: Only Y
6: Simultaneous w/ Y – X, Y and Z axes approach diagonally
XS, YS, ZS: Approach position X, Y and Z – position of the tool
tip before cycle call
CS: Approach position C – C-axis position that is approached
before cycle call with G110
Influence the departure strategy with the following parameters
(also applies for Y-axis functions).
Departure:
DEP: Type of departure
No axis – switch off the departure function
0: Simultaneously – X and Z axes depart diagonally
1: First X, then Z
2: First Z, then X
3: Only X
4: Only Z
XE, ZE: Departure position X and Z – position of the tool tip
before the movement to the tool change point
To Next Page
Loading...
