More services
506
12.9
RADIUS
BAT54-Rail/F..
Release
7.54
06/08
D Server port [default: 1.812]
Specify here the port used for communication to your RADIUS server.
D Key (shared secret)
Specify here the key to be used for coding data. The key must also be
configured on the RADIUS server.
D PPP mode [default: disabled]
A RADIUS server may be used for the authentication process when dial-
ing-in using PPP.
D Disabled: PPP clients are not authenticated using RADIUS. They are
checked exclusively using the PPP list.
D Enabled: RADIUS authentication for PPP clients is enabled. User data
supplied by clients is first checked using the PPP list. If no matching
entry is found in the PPP list, the client is checked by the RADIUS
server. Authentication is successful if the PPP list checkor RADIUS
server check returns as positive.
D Exclusive: RADIUS authentication for PPP clients is enabled. User
data supplied by clients is checked exclusively by the RADIUS server.
In this mode, it is just the advanced settings of the PPP list for the user
which are interpreted (e.g. check for PAP/CHAP – or the allowed pro-
tocols IP, IPX and/or NetBIOS).
D CLIP mode [default: disabled]
A RADIUS server may be used for control of a return call when dialing-in
using PPP.
D Disabled: The return call function is not controlled by RADIUS. Only
those entries in the name list are used.
D Enabled: The RADIUS function for the return call is enabled. Tele-
phone numbers reported by clients are first checked using the name
list. If no matching entry is found in the name list, the telephone num-
ber is checked by the RADIUS server. If the name list check or
RADIUS server check returns as positive, a return call can be estab-
lished.
Note: If the telephone number communicated is in the name list, but no re-
turn call is active there, RADIUS ceases checking.
D Exclusive: The RADIUS function for the return call is enabled. User
data reported by clients is checked exclusively by the RADIUS server.
In order to use the return call control from RADIUS, a user must be set
up on the RADIUS server for each telephone number to be authenti-
cated. The user name corresponds to the telephone number and the
user password is the CLIP password specified here.
To Next Page
Loading...
Need help?
General
