Measure piston pin bore I.D.
in
an
X and
Yaxis
.
Take the maximum reading
to
determine I.D.
SERVICE LIMIT: 13.
03
mm
(0
.513 in)
Measure the piston pin
0.0
.
at
three points.
SERViCE LIMIT: 12.98
mm
(0.511 in)
Calculate the piston-to-piston pin clearance.
SERVICE LIMIT: 0.075
mm
(0.0030 In)
CONNECTING ROD
Measure the connecting rod small end I.D.
SERVICE LIMIT: 13.05
mm
(0.514 in)
Calculate the connecting rod-to-piston pin clearance.
SERVICE LIMIT: 0.
07
mm
(0.003 In)
CYLINDER STUD BOLT
REPLACEMENT
CYLINDERJPISTON
If replacing
the
cy
linder stud bolts,
be
sure to instatl
,--
------------
---
,
them
as
shown.
Thread two nuts onto the stud bolt
11]
and tighten them
together, then use a wrench
on
them to turn the stud
bolt out.
Install and tighten new stud bolts to the specified
torque.
TORQUE
:6
N'm (0.6 kgf·m, 4.4
IbHt)
After tightening the stud bolts, check that the
incomplete threads [2] is buried into the cylinder.
/
l
9-7
To Next Page