Honda CRF110F - Cylinder Head Removal

Hold the cam sprocket [1] by using the special tooL
TOOL:
[21 Uni .... ersal Holder 07725-0030000
Apply engine oil
to the cam sprocket washer bolt [3]
threads and seating surface.
Install and tighten
the cam sprocket washer bolt to
specified torque.
TORQUE:
27 N'm (2 .8 kgf 'm, 20 IbHt)
Pour 4.0 cm
J
minimum of engine oil into the push rod.
Install a new sealing washer [1 ] and boll [2], then
tight
en it.
Apply engine oil to Ihe new crankshaft hole cap O-ring
and timing hole cap O-ring, then install them to the
caps.
Install t
he crankshaft hole cap and timing hole cap to
the left crankcase cover.
TORQUE:
Crankshaft hole cap
Timing hole cap
8 N'm
(0 .8 kgf 'm, 5.9 IbHt)
10 N'm (1 .0 kgf 'm, 7Ibf·ft)
Install t he cylinder head cover (page 8-7).
CYLINDER HEAD
REMOVAL
Remove the following:
- Cam sprocket (page 8-8)
- Exhaust pipefmuffler (page 2-8)
Disconnect the spark plug cap [
1] .
Remove the two bolts [
2] and release the intake pipe {3]
from th e cylinder head.
Remove the gasket
{4].
Remove Ihe cylinder head bolts [1].
Loosen the cylinder head nuts
{2J in a crisscross pattern
in two or three steps.
Remove the
fou r nuts an d washers [31.
CYLINDER HEADNALVES
8-11