INSPECTION
Axl.
Set the axle
[11
on V-blocks and measure the runout.
The actual runout is 1/2
of
the total indicator reading.
SERVICE LIMIT: 0.
20
mm
(0.008 in)
Wheel bearing
Tum
the inner race of each bearing with your finger.
Bearings should turn smoothly and quietly.
Also check that the bearing outer race fits tlghtly
in
the
hub.
Rep/aCfJ the
wheel
Remove and discard the bearings if the races
do
not
bearings
in
pairs.
lurn smoothly and quietly,
or
if they
fit
loosely
in
the
hub.
Install Ihe new bearings into the hub using
the
special
lools (page 15-8).
Wheel
rim
runout
REAR WHEEUBRAKE/SUSPENSION
Check
the
rim runou! by placing
th
e wheel
in
a trueing
,-----
---
---------,
stand.
Spin the wheel
by
hand, and read the runou! usi
ng
a
dial indicator.
SERVICE LIMITS:
Radial: 1.0 mm
(0
.04 in)
Axial: 1.0 mm (0.04 in)
DISASSEMBLY
Remoye the driven sprocket nuts [1], boils
[2J
and
driven sprocket [3).
8
15·7
To Next Page