Make
sure
that the
snep
ring
is firmly
seated
in
the
groove.
CRANKSHAFTITRANSMISSION/KICKSTARTER
Install the special washer [1] to the kickstarter spindle.
INSTALLATION
Apply engine oil to
the
kickstarter gear teeth.
Install the kickstarter spindle
11]
while aligning its
ratchet spring with the groove of the right crankcase
as
shown.
tnsert the return spring end into the hole
on
the right
--""1
crankcase
as
shown.
Assemble the crankcase (page 12-17).
Set the retainer
(1)
to the kickstarter spindle.
Temporarily install
the
kickstarter pedal
[2)
and bolt [3].
Turn
the
kickstarter pedal
and
completely install
the
retainer while aligning its wide tooth with Ihe wide spline
on
the spindle.
Release Ihe kickslarter pedal.
Remove the bolt and kicks tarter pedal.
Inslall Ihe snap ring [1]10 the kickstarter spindle groove.
Install the gearshift linkage (page 10-28).
[21
12-23
To Next Page