Inslatt the new piston pin clip [1].
NOTE:
Make sure the piston pin
dips
are seated securely.
Do not align the piston pin clip end gap wi
th
the
piston
cu
tout.
CYLINDER INSTALLATION
Do
not
reuse the Install the dowel pins [1] and a new gasket [2].
gasket, replace with
a
new
ona.
CYLINDER/PISTON
Apply oil to the cylinder bore, piston sliding area, piston
~::;;::::;~::::"'~~~
~~~~~
~~:~
ring grooves and piston rings whole surface.
Route the cam chain [1] through the cylinder [2].
86
careful
not
to
Instatt the cylinder over the piston while compressi
ng
damage
tM
piston the piston rings with your fingers.
rings
and
cylinder
bora.
Be careful
not
to Inst
att
the cam chain guide rotter [1], new sealing
:=='=====~~;;:=:;
;
drop the guide rollar washer
(2)
and cam chain guide rotter pin bolt [3].
into the crankcase. Tighten the rotter pin bol
ito
the specified torque.
TORQUE: 10 N·m
(1
.0
kgf
-m, 7
IbHt)
Instatt the cylinder head (page 8-19).
9·9
To Next Page