Honda CRF110F - Change Clutch Assembly

CLUTCH/GEARSHIFT LINKAGE
CHANGE CLUTCH DISASSEMBLY
Remove the clutch Jifter plate assembly [1] and washer r-- -------- ------~
[2] from the clutch outer [3) . [2)
Remove the following:
- Four bolts (1]
Clutch Jifter plate [2J
Spring [3]
Clutch center [4]
Clutch discs 15)
Clutch plates 16J
,
121 131
{4{
{11 {5J1l61
Turn the clutch spring seat [1] until its tabs [2] are ;::== === ==========~
aligned with the slols (3] on the clutch lifter plale [4].
then remove it.
CHANGE CLUTCH INSPECTION
C LUTCH LIFTER BEARING
111
{21
\
141
Temporarily install the clutch lifter bearing [1} to the r----- --- ---- -- ----,
clutch lifter plate [2].
Turn the inner race of the clutch lifter bearing with your
finger.
The bearing should turn smoothly and quieUy.
Also check that the bearing outer race of the bearing fi ts
t
ighlly in the clutch lifter plate.
Replace the bearing if the inner race does not turn
smoothly, quietly, or if the outer race fits loosely in the
clutch lifter plate.
111
[21
10-19