CLUTCH/GEARSHIFT LINKAGE
Apply
oil
to the centrifugal clutch lock nut [1] threads
and seating surface.
Inslallths
special
1001
using proper bolts or screws.
TOOL
:
[2]
Clut
ch ce
nter
hold
er 07HMB·HB70100
or 07923-HB3000B
(U
.S.A. only)
Inslall and light
en
the
centrifugal clutch lock nut to the
specified torque using the speciallools.
TOOLS:
[3]
lo
ck nut w
rench
, 20 x 24 mm 07716.0020100
[4]
Ex
ten
s ion
bar
07716-0020500
or
equivalent
commercially
available in U.S.A.
TORQUE:
54
N'm
(5
.5
kgf
'm, 40
IbHt)
If
any
of
the
centrifugal clut
ch
lock nut [1] groove is not
iO"
--
"';;;
aligned with the lock washer tab
[21,
fu
rt
her tighten t
he
centrifugal clutch lock nul and align the centrifugal
clutch lock nut groove
wi
th the lock washer tab.
Bend the lock washer lab against t
he
centrifugal clutch
lock nut groove.
Install the following:
- Engine oil centrifugal filter cover (page 3·11)
- Right crankcase cover (page 1 0·8)
GEARSHIFT LINKAGE
REMOVAL
Remove the clutch (page 10·9).
When
removing
the
Remove t
he
bolt [1] and gearshift pedal [2].
gearshift
pedal,
mark
the
pedal
position
to
ensure
the
original position.
Clean the gearshift spindle
11]
thoroughly to prevent t
he
~=~~
~'=::;;:;;;:;;;;;;
;;;;;;
!==~:;~
dirt or dust from entering the engine.
10-26
•
•
To Next Page