Honda CRF110F - Page 174

AL TERNATORISTARTER CLUTCH
11-10
Install the washer [1}.
Apply engine oil to the flywheel nut [2 ] threads and
sealing surface, then install it.
Hold the flywheel using the special tool and tighten the
flywheel nut to the specified torque.
TOOL:
[3] Flywheel holder 07725"{)040001
TORQUE: 40 N'm
(4 .1 kgf 'm, 30 IbHt)
Apply engine oil 10 the starter reduction gear [1] joumal , -------
area and gear teeth.
Install the starter reduction gear with aligning the starter
drive
gear [2 J and starter driven gear [3].
Apply engine oil to the starter reduction gear shaft [1]
whole surface.
Install the shaft into the reduction gear.
Install the le ft crankcase cover (page 11 -4) .