Honeywell Fusion4 MSC-L - Page 341

Operation - Stream Configuration
Part No.: 4418309_Rev09 Fusion4 MSC-L
Honeywell Installation & Operation Manual 5 - 153
pressure is the pressure above product vapour
pressure as it is typically stated for custody transfer
purposes.
The MSC-L implements volume conversions for the product groups
(commodity groups) as follows:
 A = Crude oil
 B = Refined products
 C = Special applications (thermal expansion factor needed)
 D = Lubricating oils
 E = NGL and LPG
 FAME = Fatty Acid Methyl Esters
 Petroleum to CNP6-70
 Ethanol mix to NBR 5992:2008 / 15639:2008
 Ethanol to MPMS 11.3.3
The volume conversion is implemented according to procedures
(calculations) prescribed in various current standards.
Standard Description
API MPMS 11.1
(2004)
Temperature and Pressure Volume Correction Factors
for Generalized Crude Oils Refined Products and
Lubricating Oils (Adjunct to: ASTM D 1250-04)
NOTE: designated as "D1250-04" in MSC-L user
interface
MSC-L volume corrections
Volume conversion
GSV = GOV * CTPL
GSV
GOV
Observed
Product volume
Calculate CTPL
Product volume
CTPL = CTL * CPL
Observed
Calculated
Calculated
Base
Measured
Configured
Product temperature
Product pressure
Product density
Commodity group
Base temperature
Base pressure
Product density(Lab)
Product temp. (Lab)
Product pressure (Lab) Thermal expansion factor
Density input usage
Commodity group standard:
MPMS 11.1 (D1250-04), etc.
GOV
= Gross Observed Volume (volume at observed T, P)
GSV
= Gross Standard Volume (volume at baseT, P)
CTL
= Correction for the effect of Temperature on Liquid
CPL
= Correction for the effect of Pressure on Liquid