CONFIGURATION AND ANALYSIS SOFTWARE ENSUITE
Information for general use
Rev. M / 73023639
8.2. Installation Start and Data Connection
8.2.1. Installing enSuite
If you do not wish to use the default parameter set, you should change the parameter set before or
during the start-up procedure. enSuite will help you do this.
One example of these discrepancies is the use of gas properties not stored in the device for the
verification or calibration.
You can download the installation program of enSuite from the Software Downloads section of the
website:
www.elster-instromet.com/de/software-downloads.
This site also contains a file
describing the installation procedure and the minimum system requirements.
Complete the installation as specified on the website. Ensure that there are no special characters in
the file path, otherwise it will not be possible to transfer files to a device.
If enSuite is already installed on your computer (parameterization device), ensure that you
have the latest version.
Also ensure that no data are overwritten by a new installation (backup copy/changing the
storage location).
Si enSuite est déjà installé sur votre ordinateur (appareil de paramétrage), assurez-vous
de disposer de la version actuelle.
Assurez-vous également qu’aucune donnée ne sera écrasée par la nouvelle installation
(copie de sécurité/changement de lieu de sauvegarde).
No restart is required after completing the installation and the shortcut symbol
shown here will appear on your desktop.
For non-fiscal operation, the enSuite configuration and analysis software also
allows communication via a network interface using the Modbus TCP protocol.
To Next Page
Loading...
