GASLAB Q2 DISPLAYS (OPERATE THE DEVICE)
Information for general use
Rev. M / 73023639
7.3.16. Display Q2 control (calibration/verification/touch)
Clicking on this symbol leads to the following display which branches to
functions “Calibration”, “Verification” and “Disable touch”.
Calibration enables you to branch into other
calibration sub-displays.
Verification enables you to start the verification
and to go to other branches.
Disable touch interrupts the device operation
for a time displayed as it runs down behind the
link. This prevents, for example, errors with a
limited time during inspections or service work.
Figure 7.42: Q2 – Control display with sub-displays
“Operational calibration”
see section 7.4.2 Operating mode: Operational calibration (manual)
“Service calibration”
see section 10.2 Completing a service calibration
Branches and functions of the verification process
see section 7.4.3 Operating mode: Verification (special mode)
Displays and functions for “Base calibration” not described
(The base calibration is only carried out by Honeywell at the factory before delivery)
To Next Page
Loading...
