SAFETY AND WARNING INFORMATION
Information for general use
Rev. M / 73023639
2.8.7. Uninstalling programs and data
Uninstall enSuite in the usual way in Windows, but only if you do not want to access any enCore
device permanently, as the uninstallation removes all enCore devices and data from your
parameterization device (PC) at the same time.
In the navigation window, remove data by selecting a line and activating Delete in the context
menu. After confirmation, the line and all subordinate entries are deleted.
If the device is disposed of, the stored data can be easily and safely removed by removing the SD
card. Without SD card the device is unusable.
If the SD card is removed improperly, additional hardware damage is possible! Disposal of
the memory card and device are subject to environmental protection regulations.
Si la carte SD est retirée de manière incorrecte, des dommages matériels supplémentaires
sont possibles ! La mise au rebut des cartes et des appareils à mémoire est soumise à la
réglementation sur la protection de l'environnement.
All data of the device is stored on the SD card.
This card is located on a separate board, called
CPU3 CORE.
Unscrew the mechanically and electrically
uninstalled device. The circuit boards (in the
housing or on the HMI module) become visible.
You will then see the CPU3 CORE board with the
SD card as shown. The SD card is located in a
holder and has a red border in the figure.
Open the holder by first sliding the cover to the
edge and then folding it forward. Now remove
the SD card and with it all data of the device.
Infmation about opening the device in section
6.1.3 Opening and closing the hardware parameter guard (SSW)
To Next Page
Loading...
